Emission Control Warranty Statement - Jonsered GC2128C Operator's Manual

These attachments used in combination with the specified powerhead have been evaluated
to ANSI B175.3- -2003, "Grass Trimmers and Brushcutters - - Safety Requirements". These
combinations have been evaluated by Underwriter's Laboratories Inc. (UL) and are conse-
quently UL listed:
Model GC2128C (M10 LH arbor shaft thread) - - Centre hole in blades/cutters, ∅ 25,4 mm
Approved accessories Type
Grass blade/grass cutter Grass 255- -4 1 inch
(∅ 250 4- -teeth)
Trimmer head T25
Plastic blades Tricut 300 mm
Support cup Fixed
Trimmer attachment - -
Trimmer head T35*
*For use only with trimmer attachment, part no. 537 35 35- -01
The accessories used in combination with the specified powerhead have been evaluated
to applicable ISO- - and EN safety requirement standards by the Swedish Machinery
Testing Institute.
Attachments
Cultivator attachment with shaft
Edger attachment with shaft
Blower attachment with shaft
Pruner attachment with shaft
U.S. EPA / CALIFORNIA / ENVIRONMENT CANADA

EMISSION CONTROL WARRANTY STATEMENT

IMPORTANT:
This product is compliant
with U.S. EPA Phase 3 regulations for
exhaust and evaporative emissions. To
ensure EPA Phase 3 compliance, we
recommend using only genuine Jonsered
brand replacement parts. Use of non-
compliant replacements parts is a
violation of federal law.
YOUR WARRANTY RIGHTS AND
OBLIGATIONS:
The U.S. Environmental Protection Agency,
California Air Resources Board, Environment
Canada and Jonsered are pleased to explain
the emissions control system warranty on
your year 2012 and later small off- -road en-
gine. In California, all small off- -road engines
must be designed, built, and equipped to meet
the State's stringent anti- -smog standards.
Jonsered must warrant the emission control
system on your small off- -road engine for the
periods of time listed below provided there
has been no abuse, neglect, or improper
maintenance of your small off- -road engine.
Your emission control system includes parts
such as the carburetor, the ignition system
and the fuel tank.
545186857 Rev. 9 5/15/12
TECHNICAL DATA
Cutting attachment / guard, part. no.
504 00 13- -03 / 545 081 703
537 33 83- -06 / 545 081 703
531 00 38- -11 / 545 081 703
- -
537 35 35- -01
537 18 54- -05 / 503 977 101
Part. no.
952 711 907
952 711 908
952 711 911
952 711 916
Where a warrantable condition exists,
Jonsered will repair your small off- -road
engine at no cost to you. Expenses covered
under warranty include diagnosis, parts and
labor.
MANUFACTURER'S WARRANTY
COVERAGE:
If any emissions related part on your engine
(as listed under Emissions Control Warranty
Parts List) is defective or a defect in the mate-
rials or workmanship of the engine causes the
failure of such an emission related part, the
part will be repaired or replaced by Jonsered.
OWNER'S WARRANTY RESPONSI-
BILITIES:
As the small off- -road engine owner, you are
responsible for the performance of the re-
quired maintenance listed in your operator's
manual. Jonsered recommends that you
retain all receipts covering maintenance on
your small off- -road engine, but Jonsered
cannot deny warranty solely for the lack of
receipts or for your failure to ensure the per-
formance of all scheduled maintenance. As
the small off- -road engine owner, you should
be aware that Jonsered may deny you
English--- 25