Advertisement
TNT Rear Panel
17
18
12
This button turns the compressor on or o .
VOLUME
13
This knob controls the overall volume of the ampli er.
DDT™ (Distortion Detection Technique)
14
This button prevents power ampli er clipping that can sound bad and damage speakers. The "IN" or
enabled for optimum system performance.
HEADHPHONE OUTPUT
15
DDT INDICATOR LIGHT
16
for the LED to ash. However, if the LED is constantly illuminated, the gain level needs to be adjusted to
prevent possible equipment damage. When the DDT is defeated, the LED becomes a clip indicator.
POWER SWITCH
17
To apply power to the unit, ip the switch to the "On" position. The blue LED will illuminate, indicating
power is being supplied.
Caution: The on/off switch in this unit does not break both sides of the primary mains.
Hazardous energy can be present inside the chassis even when the on/off switch is in the
OFF position.
AC POWER INLET:
18
This is the receptacle for an IEC line cord, which provides AC power to the unit. Connect the line cord to
this connector to provide power to the unit. Damage to the equipment may result if improper line volt-
age is used. (See line voltage marking on unit).
Never break o the ground pin on any equipment. It is provided for your safety. If the outlet used does
not have a ground pin, a suitable grounding adapter should be used, and the third wire should be
grounded properly. To prevent the risk of shock or re hazard, always make sure that the ampli er and all
associated equipment is properly grounded.
NOTE: FOR UK ONLY
As the colors of the wires in the mains lead of this apparatus may not correspond with the colored mark-
ings identifying the terminals in your plug, proceed as follows: (1) The wire that is colored green and yel-
low must be connected to the terminal that is marked by the letter E, or by the Earth symbol, or colored
green or green and yellow. (2) The wire that is colored blue must be connected to the terminal that is
marked with the letter N, or the color black. (3) The wire that is colored brown must be connected to the
terminal that is marked with the letter L, or the color red.
19
9
22
23
20
21
24
Advertisement
