Iwatsu ICON IX-5930 Series Quick Reference Manual page 28

BLUETOOTH CONDITIONS
Refer to the Setup Menu section on page 6 for
Bluetooth Discover (Pairing), Connect, and Discon-
nect procedures.
Disclaimer: The compatibility and performance of
any Bluetooth headset not manufactured by Iwatsu
is "As is" and is not supported, warranted, or guar-
anteed by Iwatsu in any manner, and Iwatsu hereby
disclaims any and all implied warranties of mer-
chantability and fitness for a particular purpose.
Bluetooth Operating Conditions
• If Bluetooth does not appear on your LCD when
you press the Setup key, your telephone is not
equipped with a Bluetooth module.
• Only one Bluetooth headset can be paired to a
telephone at a time. A second device will over-
write any previously paired Bluetooth headset.
• For convenience and visibility, Iwatsu recom-
mends adding a Headset Control Key to your
key pattern.
• If Unknown appears on the display during the
Bluetooth Discovery process, it is possible that
the Bluetooth Name Check Response Timer has
timed out before the headset name was re-
ceived. In most cases, the Bluetooth device will
pair successfully. You can choose to re-discover
the Bluetooth device if the name does not ap-
pear on your display.
Bluetooth Environmental Conditions
The following environmental conditions will have an
effect on the operation of Bluetooth headsets and
must be taken into consideration:
• Number of Bluetooth devices within a 10 meter
radius of the Bluetooth enabled Iwatsu ICON
Series telephone.
• Number of WiFi devices within a 10 meter radius
of the Bluetooth enabled Iwatsu ICON Series
telephone.
• Distance of the Bluetooth headset from the Blue-
tooth enabled Iwatsu ICON Series telephone.
Note: When the Motorola H550 headset is taken
out of range and then returned within range of the
paired key telephone, the H550 headset LED will
flash red and you will hear a beep approximately
every 30 seconds. To clear this state, power the
headset off and then on and wait for the headset to
reconnect.
27