Troubleshooting Table; Declaration Of Conformity - Jonsered GT26D Instruction Manual

TROUBLESHOOTING TABLE

WARNING:
recommended remedies below except remedies that require operation of the unit.
TROUBLE CAUSE
Engine will not
1. Engine flooded.
start.
2. Fuel tank empty.
3. Spark plug not firing.
4. Fuel not reaching
5. Carburetor requires
1. Carburetor requires
Engine will
not idle
2. Crankshaft seals worn.
properly.
3. Compression low.
Engine will not
1. Air filter dirty.
accelerate,
2. Spark plug fouled.
lacks power,
or dies under
3. Carburetor requires
a load.
4. Carbon build-up on
5. Compression low.
Engine 1. Choke partially on.
smokes 2. Fuel mixture incorrect.
excessively.
3. Air filter dirty.
4. Carburetor requires
Engine runs 1. Fuel mixture incorrect.
hot.
2. Spark plug incorrect.
3. Carburetor requires
4. Carbon build-up on

DECLARATION OF CONFORMITY

EU Declaration of Conformity relating to 2000/14/EC
We, Poulan/Weed Eater, Division Electrolux North America, Inc., Texarkana, TX,
75501, USA, Tél. : +1 903 223 4100, declare under sole responsibility that the Jonsered
model GT26D brushcutter was assessed in accordance with Annex V of the DIRECTIVE
and from serial numbers 2001--305N00001 and onwards, conforms to the provisions of the
DIRECTIVE. The net power is 0,8 kW. The measured sound power is 108,4 dB and the
guaranteed sound power is 112 dB.
Texarkana 01--12--17
Always stop unit and disconnect spark plug before performing all of the
carburetor.
adjustment.
adjustment.
adjustment.
muffler outlet screen.
adjustment.
adjustment.
muffler outlet screen.
relating to 2000/14/EC
REMEDY
1. See "Starting a Flooded Engine" in
Operation Section.
2. Fill tank with correct fuel mixture.
3. Install new spark plug.
4. Check for dirty fuel filter; replace.
Check for kinked or split fuel line;
repair or replace.
5. See "Carburetor Adjustment" in
Service and Adjustments Section.
1. See "Carburetor Adjustment" in
Service and Adjustments Section.
2. Contact an authorized service dealer.
3. Contact an authorized service dealer.
1. Clean or replace air filter.
2. Clean or replace plug
and regap.
3. See "Carburetor Adjustment" in
Service and Adjustments Section.
4. Contact an authorized service dealer.
5. Contact an authorized service dealer.
1. Adjust choke.
2. Empty fuel tank and refill with
correct fuel mixture.
3. Clean or replace air filter.
4. See "Carburetor Adjustment" in
Service and Adjustments Section.
1. See "Fueling Engine" in Operation
section.
2. Replace with correct spark plug.
3. See "Carburetor Adjustment" in
Service and Adjustments Section.
4. Contact an authorized service dealer.
Michael S. Bounds, Director
Product Safety and Standards
12