Appendix; Troubleshooting - LevelOne WCS-2010 User Manual

Appendix

A. Troubleshooting
Status LED
After powering up, the Network Camera performs a self-diagnostic to detect any hardware
defects. The following table lists the LED patterns in general. In case of any fatal error, the
LED will blink in a pattern other than those below.
Condition
During self-diagnostic after power on
Ethernet signal is lost
Before network is setup
After network is setup
Any hardware failure
Reset and Restore
Restoring the factory defaults
will erase any previous settings.
Reset or restore the system
after power on.
LED color
Blink in interchanged green and red
Red LED is blinking till Ethernet is detected
Steady green till IP address is confirmed
Blink green every second
Other patterns
At the left side of the camera there is a button
hidden in the pinhole as shown in the picture. It is
used to reset the system or restore the factory
default settings. Sometimes resetting the system
sets the system back to normal state. If the system
problems remain after reset, restore the factory
settings and install again.
RESET: Poke the wrench to click on the button.
RESTORE: 1. Poke the wrench to press on the
button continuously.
2. Wait for self-diagnostic to run twice.
3. Withdraw the wrench as soon as the second
self-diagnostic starts.
47