Key To Symbols; Symbols On The Machine; Symbols In The Operator's Manual - Jonsered CS 2240 Operator's Manual

Symbols on the machine:

WARNING! Chain saws can be
dangerous! Careless or improper use
can result in serious or fatal injury to the
operator or others.
Please read the operator's manual
carefully and make sure you
understand the instructions before
using the machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
Both of the operator ' s hands must be
used to operate the chain saw.
Never operate a chain saw holding it with
one hand only.
Contact of the guide bar tip with any
object must be avoided.
Tip contact may cause the guide bar to
move suddenly upward and backward
(so-called kickback), which may cause
serious injury.
Recommended cutting
equipment in this example:
- Bar length 15 inches
- Max. nose radius 10
Teeth
- Chain type Jonsered H30
Other approved bar and chain
combinations in Operator's Manual.
Measured maximum kickback value
without triggering the brake, for the bar
and chain combination on the label.
Air purge
Other symbols/decals on the machine refer to special
certification requirements for certain markets.
2 – English

KEY TO SYMBOLS

Symbols in the operator's
manual:
Switch off the engine before
carrying out any checks or
maintenance. CAUTION! The
start/stop switch automatically
returns to run position. In order
to prevent unintentional
starting, the spark plug cap
must be removed from the spark plug when assembling,
checking and/or performing maintenance.
Always wear approved protective
gloves.
Regular cleaning is required.
Visual check.
Protective goggles or a visor must
be worn.
Refuelling.
Filling with oil and adjusting oil
flow.
The chain brake should be
activated when starting.
WARNING! Kickback may occur
when the nose or tip of the guide bar
touches an object, and cause a lightning
fast reverse reaction, kicking the guide
bar up and towards the operator. May
cause serious personal injury.