Onchip Ide Device; Ide Hdd Block Mode; Ide Dma Transfer Access - DFI-ITOX EL109-N User Manual

OnChip IDE Device

Move the cursor to this field and press <Enter>. The following screen will appear.

IDE HDD Block Mode

IDE DMA Transfer Access

On-Chip Primary PCI IDE
On-Chip Secondary PCI IDE
*** On-Chip Serial ATA Setting ***
x SATA Mode
On-Chip Serial ATA
x SATA PORT Speed Settings
x PATA IDE Mode
SATA Port
: Move Enter: Select
↑↓→←
F5: Previous Values
The settings on the screen are for reference only. Your version may not be identical to
this one.
IDE HDD Block Mode
Enabled
The IDE HDD uses the block mode. The system BIOS will check the hard disk
drive for the maximum block size the system can transfer. The block size will
depend on the type of hard disk drive.
Disabled
The IDE HDD uses the standard mode.
IDE DMA Transfer Access
This field is used to enable or disable the DMA transfer function of an IDE
hard drive.
Phoenix - AwardBIOS CMOS Setup Utility
OnChip IDE Device
Enabled
Enabled
Enabled
Enabled
IDE
Auto
Normal
Primary
P1, P3 is Secondary
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
BIOS Setup
Item Help
Menu Level

If your IDE hard drive
supports block mode
Select Enabled for
automatic detection of
the optimal number of
block read/writes per
sector the drive can
support
ESC: Exit F1: General Help
F7: Optimized Defaults
3
59