KYMCO 50 Owner's Manual page 49

MAINTENANCE
1 1 1 1 1
1. Place a suitable container (drain pan) under the left crank-
case. Remove the drain bolt 1 to drain the oil.
2. Remove the oil filler/dipstick 2 from the right crankcase
cover.
2 2 2 2 2
3. Replace the drain bolt 1. Tighten it to the specified torque.
Oil drain plug torque: 18 lb-ft (25 N-m)
4. Add engine oil through the oil filler/dipstick hole.
Engine oil capacity (50):
Engine oil capacity (125 & 200): 1.20 qt (1.10 L)
Engine oil viscosity:
Do not overfill the engine with oil. Overfilling the en-
gine can cause oil leaks and/or oil contamination of
the air filter element. Always make sure the oil level is
above the "L" mark but not higher than the "F" mark
on the dipstick.
5. Refer to page 24: Wipe the dipstick off with a clean cloth and
reinstall it in its hole, but do not thread it into the engine
case. Push the dip stick in until it touches the case.
6. Remove the dip stick and visually inspect the oil level on the
stick. The engine oil level should be above the "L" mark but
not higher than the "F" mark. Add or remove oil as required.
7. Replace the oil filler/dipstick and tighten it securely.
0.90 qt (0.85 L)
SAE 10W-40
47