Engine Oil Inspection; Tire Inspection - KYMCO 50 Owner's Manual

OPERATION
PRI - Engine oil level inspection
NOTE: Park your scooter on the main stand, on level ground.
1 1 1 1 1
1. Unscrew the dip stick 1, remove it and wipe it with a clean cloth
2. Reinsert the dip stick until the threaded part of the dip stick
touches the engine case. Do not thread the dipstick into the
engine case.
3. Remove the dip stick again and inspect the oil level on the
stick. The engine oil level should be above the "L" mark but
not higher than the "F" mark. Add or remove oil as required.
Do not overfill the engine with oil. Overfilling the en-
gine can cause oil leaks and/or oil contamination of
the air filter element. Always make sure the oil level is
above the "L" mark but not higher than the "F" mark.
24
Use extreme caution when performing the oil level in-
spection or any other checks if the scooter's engine
has been recently operated. The engine oil, engine case
F
and muffler can become very hot creating a burn hazard.
PRI - Tire inspection
The condition of your scooter's tires is vital for operational ef-
L
ficiency and your safety. Check the tires' inflation pressure 2,
the tread depth, and for damage before each ride.
Front tire (rider only):
Rear tire (rider only):
Front tire (rider & passenger): 25.0 PSI (1.75 kg/cm
Rear tire (rider & passenger): 32.0 PSI ( 2.25 kg/cm
2 2 2 2 2
22.0 PSI (1.50kg/cm )
2
29.0 PSI (2.0 kg/cm )
2
)
2
)
2