Sound Skip Check Result Display Mode; Key Check Mode - Sony Mz-G750 Service Manual

MZ-G750/R700

4-10. Sound Skip Check Result Display Mode

This set can display the count of errors that occurred during the
recording/playing for checking.
• Setting method of sound skip check result display
mode
1. Set the test mode (see page 12).
[REC]
2. Press the key or
N
sound skip result display mode becomes active respectively
where the LCD displays the following.
This set LCD display
P R
Total count record
Total count of play
system errors(hex.)
system errors(hex.)
3. When the N key is pressed, total error count is displayed on
the LCD, and each time the
item moves down by one as shown below. Also, if the
is pressed, the display item moves up by one, then if the
key is pressed, the display in the record mode appears.
[REC]
When the key is pressed, total error count is displayed
on the LCD, and each time the
item moves down by one as shown below. Also, if the
is pressed, the display item moves up by one, then if
the key is pressed, the display in the play mode appears.
N
Playing sound skip
result display
0 00
P R
0 00
EIB
0 00
Stat
0 00
Adre
0 00
BEmp
0 00
######
P R :Total play/record errors(hex.)
:Counter of sound skip check each item(hex.)
:6-digit address where sound was skipped last(hex.)
######
16
key, and the playing or recording
0 00
> key is pressed, the display
. key
[REC]
> key is pressed, the display
key
.
Recording sound skip
result display
0 00
P R
0 00
BOvr
0 00
Bful
0 00
Rtry
0 00
######
• Cause of Sound Skip Error
Cause of error
EIB
Stat
Play
Adrs
BEmp
BOvr
Record
Bful
Rtry
4. To quit the sound skip check result display mode and to return
to the test mode (display check mode), press the

4-11. Key Check Mode

This set can check if the set and remote commander function nor-
mally.
• Setting Method of Key Check Mode
1. Setting the test mode (see page 12).
[T MARK]
2. Press the key for several seconds (about 3 seconds)
activates the key check mode. (At the last two digits, AD value
of remote commander key line is displayed in hexadecimal)
This set LCD display
: AD value of the remote commander Key
(hexadecimal OO to FF)
3. When each key on the set and on remote commander is pressed,
its name is displayed on the LCD. (The operated position is
displayed for 4 seconds after the slide switch is operated. If
any other key is pressed during this display, the remote com-
mander LCD switches to its name display)
Example1: When key on the set is pressed:
>
This set LCD display
FF
: AD value of the remote commander Key
(hexadecimal OO to FF)
Example2: When N >
pressed:
This set LCD display
rPLAY
: AD value of the remote commander Key
(hexadecimal OO to FF)
Description of error
Sound error correction error
Decoder status error
Address access error
Buffer is empty
Buffer is full, and sounds were
dumped
Buffer capacity becomes less,
and forcible writing occurred
Retry times over
key.
x
0 00
0 00
key on the remote commander is
0 00