Shifting - Yamaha YFZ45RB Owner's Manual

G The clutch is disengaged with the transmission
in gear. However, it is recommended to shift into
neutral before starting the engine.
4. Completely close the throttle lever and start
the engine by pushing the start switch.
TIP
If the engine fails to start, release the start switch,
then push it again. Pause a few seconds before
the next attempt. Each cranking should be as short
as possible to preserve battery energy. Do not
crank the engine more than 10 seconds on each
attempt.
ECB00163
NOTICE
For maximum engine life, never accelerate
hard when the engine is cold!
EBU20522

Shifting

This ATV has a 5-speed forward transmission. The
transmission allows you to control the amount of
power you have available at a given speed or for
starting, accelerating, climbing hills, etc.
To shift into neutral, release the throttle lever, ap-
ply the clutch, and then repeatedly depress the
shift pedal until it stops.
When it stops, it will be in first gear. Raise the pedal
slightly to reach the neutral position, and then re-
lease the clutch.
5
4
3
2
N
1
2
1. Shift pedal
2. Neutral position
EBU20592
To start out and accelerate
1. Release the throttle lever, apply the front or
rear brake, and then release the parking
brake.
6-2
1
6