Sanyo SAP-CRV93EHN Technical & Service Manual page 74

Sanyo ilmalämpöpumput korjaa ja huoltaa pääkaupunkiseudulla: Jäähdytinpalvelu RefGroup Oy
Anti-Mold Filter
How to remove the anti-mold
Cleaning
How to replace the anti-mold
OI-671-23EG
Care and Cleaning (continued)
The anti-mold filter behind the air intake grille should be checked and cleaned
at least once every two weeks.
1. Grasp both ends of the air
filter intake grille, and remove it
by opening towards the
front and pulling towards
you.
2. Remove the anti-mold filter
attached to the rear of the
air intake grille.
Use a vacuum cleaner to remove light dust. If there is sticky dust on the filter,
wash the filter in lukewarm, soapy water, rinse it in clean water, and dry it.
1. With the FRONT mark of
filter the anti-mold filter at the
front, align the two
indentions near the mark
with the hooks at the rear
of the air intake grille, and
then mount the anti-mold
filter.
2. Allow the edge of the air
intake grille to slide into the
top of the indoor unit, and
then insert it all the way
inside.
3. Press in the bottom right
and left corners of the air
intake grille to attach the
indoor unit.
Attach so that the round pins at the top right and left corners of the air intake
NOTE
grille are inserted into the grooves at the top right and left of the indoor unit.
www.ilmalämpöpumput.com
Air intake grille
Anti-mold filter
Anti-mold filter
FRONT mark
Hook
Groove
Pin
Air intake grille
Air intake grille
23