Replacing The Processor - Fujitsu Siemens Computers PRIMERGY TX200 S4 Options Manual

Processors
6.2

Replacing the processor

V
CAUTION!
Only processors of the same type may be used on the system board. The
second processor must have at least the same clock frequency as the
first processor. If the two processors have different clock frequencies,
they both will operate with the lower clock frequency.
For dual operation, use a suitable multiprocessor operating system.
Ê Open the server, remove the system fan 1, the system fan 2 and the traverse
as described in the
Ê Loosen the four screws of the heat sink in a crossover pattern.
Ê Loosen the heat sink by turning it back and forth and then lift it out.
Ê Remove the residual thermal paste from the underside of the heat sink.
Ê Clean the underside of the heat sink using a lint-free cloth.
1
Figure 17: Removing an old processor
Ê Release the socket lever by pressing it sideways and pull it upward as far as
it will go (1).
Ê Open the cover (2).
Ê Lift the installed processor carefully out of the socket (3).
TX200 S4
chapter "Preparation" on page 21
Options Guide
Replacing the processor
et seq..
2
3
35