PB10
Safety Information ............................................................................3
Speaker Connection ..........................................................................7
Operation .......................................................................................10
Troubleshooting...............................................................................11
Testing Procedures...........................................................................22
Schematics Version 1
PB10 - DIFFERENCES IN REVISION 1 AND REVISION 2
REVISION 1
Amplifier faceplate says "Made in Canada"
Amplifier serial number starts with "AM"
Black (or silver) potted, non-serviceable output module
BOTH VERSIONS OF THESE AMPLIFIERS ARE NOT CONSIDERED INTERCHANGEABLE; THEY ARE NOT A
DROP-IN REPLACEMENT IN THE CABINET OF THE OTHER VERSION.
TABLE OF CONTENTS
REVISION 2
Amplifier has main power switch
Amplifier serial number starts with "HA"
Output transistors in the open, on a large black heatsink
Large plastic cup enclosing the rear of the amp assembly
Main PCB, bottom, solder-side contains all SMD devices
"Made in Mexico" label on outer part of cabinet