Advertisement
Quick Links
Advertisement
Related Manuals for JBL PS Series
Summary of Contents for JBL PS Series
- Page 1 PS SERIES POWERED SUBWOOFERS OWNER’S MANUAL PS60/230 PS100/230 PS120/230...
-
Page 2: General Instructions
English GENERAL IN CASE OF MOVING THE UNIT Before moving the unit, be sure to INSTRUCTIONS pull out the power cord from the AC outlet and disconnect the inter- USE THE CORRECT AC connection cords with other units. VOLTAGE Connecting the unit to an outlet DO NOT OPEN THE CABINET supplying a higher voltage may To prevent shock hazard, do not... - Page 3 They will provide many years of excellent performance. Our PS Series rivals the performance of more expensive powered subwoofers. It gives you remarkably accurate and pleasing sound reproduction. Amplified Subwoofer:...
- Page 4 Preparing the speaker level connections. Review your hookup wire receiver/T.V./source amplifier Your JBL dealer can recommend instruction manual to see which suitable cables, or you can buy outputs your equipment provides, wire at most hardware stores.
- Page 5 English Speaker Level Output Crossover Level (to external speakers) Frequency – – FIG. 1: 50 (Hz) Line Level Input Connection Reverse Normal – – Polarity Line Input Speaker Level Input (from amplifier) PS Subwoofer RCA Phono Cables – – Receiver, TV, or Amplifier Speaker Level Output Crossover Level...
- Page 6 Connecting the PS subwoofer this minimum size. If your PS way ensures that both channels subwoofer is more than 30 feet will be in phase; that is, working (10 m) from your receiver/T.V./ together not in opposition. source amplifier, use larger diameter wire.
- Page 7 English NOTE: Connecting your satellite Turn power switch to On and use speakers through your PS the "Level" knob to add the subwoofer won't change their appropriate amount of bass to impedance. your main speaker output. Increase the subwoofer level by LEVEL turning level knob clockwise until NOTE: when first setting up...
- Page 8 green. After approximately 3 CROSSOVER FREQUENCY minutes of non-use (no signal Use the crossover frequency knob being received), your PS to adjust the upper end of the subwoofer goes into the auto subwoofer's frequency response. shut-off mode. The LED turns The crossover control determines RED to signify this stand-by the highest frequency your...
- Page 9 You should repeat this procedure if you move your PS subwoofer to another part of the room. ALC PROTECTION CIRCUITRY Your PS series amplifier has a built in Automatic Level Control Declaration of Conformity circuitry that comes on automatically when subjected to high input signal levels.
- Page 10 For this reason, PS Series loudspeakers may differ in some respect from their published specifications and descriptions, but will always equal or exceed the original...
- Page 11 JBL Consumer Products, Inc. 80 Crossways Park West Woodbury, NY 11797 8500 Balboa Blvd. Northridge, CA 91329 Part No. 306878-001...