Installation Instruction - LG PQRCUSA1 Owners & Installation Manual

Installation instruction

1. Connect the remote controller
cable to the wired remote
controller installation board as
shown in the right picture.
12V
SIG
GND
❊ The remote controller cable is connected as factory default.
2. After fixing the cable to the guide
slot, attach the wired remote
controller installation board at the
desired location.
• Before fixing the remote controller cable to the
guide slot, remove any clogged part of the
case in the direction to install before the
installation.
3. After locating the wired remote
controller installation board at the
desired location, screw the unit
firmly. (When there is a buried
box, install the wired remote
controller board to fit the buried
box.)
• Use the screws provided.
Red wire
Yellow wire
Black wire
installation board>
12V SIG GND
Red
Yellow
Black
<Front side of
Top
Fixate the remote
controller cable
to the guide slot.
Installation board
Bottom
Owner's & Installation Manual 5
Installation instruction
Remote Controller
Cable
Guide slot
<Rear side of
installation board>
Wall
Use the screws
Side
for fixate the unit
firmly on the wall.