Step 13 - Connect Drain Line; Drain Line Installation - GE Built-In Dishwasher Installation Instructions Manual

STEP 13 – CONNECT DRAIN LINE
FOLLOW ALL LOCAL CODES AND ORDINANCES.
The drain hose molded end will fit 5/8",3/4"or 1"
diameter connections on the air gap, waste tee or
disposer . Cut on the marked line as required for your
installation.
Cutting Lines
C u t t i n g L i n e s
1 " 3 / 4 "
IMPORTANT:Do not cut corrugated
IMPORTANT: Do not cut corrugated
portion of hose
por tion of hose
for a total of 10ft. to the factory installed hose.
Use 5/8"or 7/8"inside diameter hose and a coupler to
connect the two hose ends. Secure the connection with
hose clamps.
Hose Clamp
Hose Clamp
disposer with clamps.
Installation Instructions
5 / 8 "
F i g ur e 20
Hose Clamp
Coupler
Coupler
Figure 21
.

DRAIN LINE INSTALLATION

using either previously determined method.
Method 1- Air gap with waste tee or disposer
Waste Tee Installation
Method 2- High drain loop with waste tee or disposer
Fasten to underside
of countertop
32"
Min.
18"
Min.
Waste Tee Installation
IMPORTANT -
When connecting drain line to
disposer , check to be sure that
drain plug has been removed.
DISHWASHER WILL NOT DRAIN
IF PLUG IS LEFT IN PLACE.
TIP: Avoid unnecessary service call char ges. Always
be sure disposer drain plug has been removed before
attaching dishwasher drain hose to the disposer .
10
Disposer Installation
Figure 22
Fasten to underside
of countertop
18"
Min.
Disposer Installation
Figure 23
Remove
Remove
hopper
Hopper
plug
Plug