Step 9 Connect Drain Line; Step 10 Connect Electrical - GE Monogram ZBD6400 Installation Instructions Manual

Built-in dishwashers
Hide thumbs Also See for Monogram ZBD6400:
Table of Contents

Advertisement

STEP 9 CONNECT DRAIN LINE

FOLLOW ALL LOCAL CODES AND ORDINANCES.
• The dishwasher is supplied with a 72" long drain hose.
• If a longer drain hose is required, add up to 48" of
length for a total of 10 ft. length.
• Secure the drain hose to the air gap, waste tee or
disposer with clamps.
• Make sure drain hose is not kinked.
IMPORTANT: When connecting
drain line to disposer, check to be
sure that drain plug has been
removed. DISHWASHER WILL
NOT DRAIN IF PLUG IS LEFT
IN PLACE.
Method 1 – Air gap with waste tee or disposer
Waste Tee Installation
Method 2 – High drain loop with waste tee or disposer
Waste Tee Installation
Fasten to underside
of countertop
30"
Min.
12"
Min.
Waste Tee Installation
Installation Instructions
Remove
Plug
Disposer Installation
Fasten to underside
of countertop
30"
12"
Min.
Min.
Disposer Installation

STEP 10 CONNECT ELECTRICAL

FOR DIRECT WIRE ONLY
(If a power cord with plug is used, plug it into the wall
outlet and continue with next step.)
Verify that power is
turned off at the
source.
Insert power cord wires
through strain relief and
tighten.
• Locate the three dishwasher wires, (white, black and
green) with stripped ends. Insert wire through the
small hole in the junction box. Use wire connectors to
connect incoming ground to green, white to white and
black to black.
• Install junction box cover with screws provided. Check
to be sure that wires are not pinched under the cover.
• Reinstall Insulation Board in position. The board
should be secured so it does not interfere with door
opening.
If house wiring is not 2-wire with
ground, a ground must be provided
by the installer. When house wiring is
aluminum, be sure to use UL Listed
anti-oxidant compound and alumi-
num-to-copper connectors.
AVERTISSEMENT
Si l'installation électrique de la maison
n'est pas à deux fils plus terre,
l'installateur doit installer un fil de
mise à la terre. Si l'installation
électrique de la maison est en alu-
minium, il faut prendre soin d'utiliser
des composés antioxydants et des
connecteurs aluminium à cuivre sur la liste UL.
12
Ground
White
Black

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents