Before Playing With The Surround Function - Denon AVR-1802 Operating Instructions Manual

0
13 SURROUND
l
Before playing with the surround function, be sure to use the test tones to adjust the playback level from each speakers. This adjustment can
be performed from the remote control unit, as described below.
l
The adjustment with the test tones is only effective in the DOLBY/DTS SURROUND modes.
The adjusted playback levels for the different surround modes are automatically stored in the memory of each surround modes.
1 Set the DOLBY/DTS SURROUND (Dolby Pro Logic II or Dolby
Digital or DTS) modes.
(Man unit) (Remote control untt)
Press T. TONE button.
IT.TONEI
RETUR
-3
(Remote control wt)
Test tones are output from the
different speakers. Use the channel
El
volume adjust buttons to adjust so
Ob
7
that the volume of the test tones is
the same for all the speakers.
(Remote control unit)
NOTE: Please make sure the "AUDIO" position of the slide
switch on the remote control unit.
3 After completing the adjustment, press T. TONE button again.
RETUR
%
(Remote control umt)
l
After adjusting using the test tones, adjust the channel levels either according to the playback sources or to suit your tastes, as described below.
1 Select the speaker whose level you want to adjust.
.
CH "In
y& zq$
(Main unit) (Remote control unit)
1010 . .
0000~0~
c3 0
The channel switches as shown below each time the button
Yl=
-
-
is pressed.
-pvJ-
I
NOTE: Please make sure the "AUDIO" position of the slide
switch on the remote control unit.
2-
2 Adjust the level of the selected speaker.
l-
(Main unit)
(Remote control unit)
% The level of the selected speaker can be adjusted within
the range of +I2 to -12 dB using the SELECT (up and
down) buttons.
30