AEG L 77685 WD User Manual
  1. Manuals
  2. Brands
  3. AEG Manuals
  4. Washer
  5. L 77685 WD
  6. User manual

AEG L 77685 WD User Manual

Hide thumbs Also See for L 77685 WD:
Table of Contents

Advertisement

Quick Links

EN User manual
L 77685 WD

Advertisement

Table of Contents
loading

Related Manuals for AEG L 77685 WD

Summary of Contents for AEG L 77685 WD

  • Page 1 EN User manual L 77685 WD...

  • Page 2: Table Of Contents

    15. INSTALLATION ............32 FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler –...

  • Page 3: Safety Information

    ENGLISH 1. SAFETY INFORMATION Before the installation and use of the appliance, careful- ly read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use cau- ses injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability.

  • Page 4: Safety Instructions

    • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly quali- fied persons in order to avoid a hazard. • The operating water pressure (minimum and maxi- mum) must be between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa) •...

  • Page 5: Water Connection

    ENGLISH Water connection sene, spot removers, turpentine, wax- es and wax removers, wash them in • Make sure not to cause damage to the hot water with an extra amount of de- water hoses. tergent. • The appliance is to be connected to •...

  • Page 6: Technical Information

    • Disconnect the appliance from the • Remove the door catch to prevent mains supply. children and pets to get closed in the appliance. • Cut off the mains cable and discard it. 3. TECHNICAL INFORMATION Dimensions Width / Height / Depth...

  • Page 7: Product Description

    ENGLISH 4. PRODUCT DESCRIPTION Worktop Feet for the appliance level Detergent dispenser Water drain hose Control panel Water inlet valve Door handle Mains cable Rating plate Transit bolts Drain pump Feet for the appliance level 4.1 Accessories Spanner To remove the transit bolts. Plastic caps To close the holes on the rear side of the cabinet after the removal of...

  • Page 8: Control Panel

    5. CONTROL PANEL Koch/Bunt + Vorwäsche Pflegeleicht + Vorwäsche Leichtbügeln Wolle Feinwäsche Wolle/Seide 20 Min. - 3 kg On off button (Ein/Aus) Timed drying button (Trockenzeit) Programme knob Automatic drying button (Trocken- grad) Display Spin speed button (U./Min.) Start pause button (Start/Pause) Temperature button (Temp.)
  • Page 9 ENGLISH • The default spin speed of the programme. • 'No Spin' and 'Rinse Hold' symbols. Dryness levels symbols: Iron dry Store dry Extra dry The display symbols: Washing phase Drying phase Extra rinse Child lock You cannot open the appliance door when the symbol is on. You can open the door only when the symbol goes off.

  • Page 10: Delay Start Button

    10 www.aeg.com • To deactivate the function press but- 5.4 Start/Pause button and button at the same Press button to start or interrupt a time until the symbol goes off. programme. 5.10 Spin button 5.5 Delay start button Press this button to:...

  • Page 11: Programmes

    ENGLISH • To activate the function, press button You can activate the function: and button at the same time • Before you press the Start/Pause but- until the display shows the symbol : the appliance cannot start. • To deactivate the function, press but- •...
  • Page 12 12 www.aeg.com Programme Type of load Cycle Functions Temperature max. weight of load description Feinwäsche Delicate fabrics as Wash SPIN REDUC- 40° - Cold acrylics, viscose, pol- Rinses TION yester items with nor- Short spin RINSE HOLD mal soil. EXTRA RINSE max.
  • Page 13 ENGLISH Programme Type of load Cycle Functions Temperature max. weight of load description WASHING PROGRAMMES Mixed fabrics (cotton Wash SPIN REDUC- Super Eco and synthetic items). Rinses TION Cold max. 3 kg Short spin RINSE HOLD EXTRA RINSE Baumwolle Eco White and fast col- Wash SPIN REDUC-...
  • Page 14 14 www.aeg.com 6.1 Programmes for automatic drying Level of dryness Type of fabric Load Cotton and linen Extra dry (bathrobes, bath towels, up to 6 kg For towelling materials etc) Cotton and linen (bathrobes, bath towels, up to 6 kg...

  • Page 15: Consumption Values

    ENGLISH • The wool drying cycle of this machine has been tested and approved by The Woolmark Company. The cycle is suit- able to dry wool garments which are labelled «hand wash» provided that the garments are washed in a Wool- mark endorsed washing machine and tumble dried according to the instruc- •...

  • Page 16: Before First Use

    16 www.aeg.com 8. BEFORE FIRST USE To activate the drain system, put 2 li- detergent dispenser. Set and start a tre of water in the main wash com- programme for cotton at the highest partment of the detergent dispens- temperature without laundry. This removes all possible dirt from the drum and the tub.

  • Page 17: Check The Position Of The Flap

    ENGLISH The detergent compartment for the prewash phase, the soak programme and for the stain function. Add the detergent for prewash, soak and stain remover before the start of the programme. The detergent compartment for the washing phase. If you use a liquid detergent, put it immediately before you start the programme.
  • Page 18 18 www.aeg.com To use liquid detergent, turn the flap down. With the flap in the position DOWN: – Do not use gelatinous or thick liquid detergents. – Do not put more liquid deter- gent than the limit showed in the flap.

  • Page 19: Open The Door

    ENGLISH • The acoustic signals operate. Press button , the appliance starts the countdown of the delay • In the display comes on. start. • The indicator of the Start/Pause but- When the countdown is completed, goes off. the programme starts automatically. •...

  • Page 20: Using The Appliance - Drying Only

    20 www.aeg.com 10. USING THE APPLIANCE - DRYING ONLY WARNING! The display shows a minimum time value. Set time value Open the water tap. Put the drain hose in the sink or connect to the • Each time you press this button the drain pipe.

  • Page 21: Using The Appliance - Washing & Drying

    ENGLISH 11. USING THE APPLIANCE - WASHING & DRYING 11.1 NON-STOP programme - The display shows the new time value each minute. Washing & Automatic drying The last minutes of the drying cy- CAUTION! cle the appliance performs the Do not put a plastic device/ball anti-crease and the cooling pha- for the detergent into the ses.

  • Page 22: Helpful Hints And Tips

    22 www.aeg.com The released fluff could stick to the fab- Final time value (washing rics during the next cycle. + drying + anti-crease + This inconvenient increases with techni- cooling phases) cal fabrics. To prevent the fluff in your laundry, we...

  • Page 23: Water Hardness

    ENGLISH • A very small load can cause balance • If you use liquid detergents, do not set problems with the spin phase. If this the prewash phase. occurs, adjust manually the items in • If your appliance has not the deter- the tub and start the spin phase again.

  • Page 24: Care And Cleaning

    24 www.aeg.com – Sleeping bags • weight of the load size GENERAL TIPS – Fabrics with residue of hair sprays, nail Refer to the «Drying programmes» table solvents or similar. to find the average drying times. – Garments with foam-rubber or materi- The experience will help you to dry the als similar to foam-rubber.

  • Page 25: Door Seal

    ENGLISH 13.4 Door seal Regularly examine the seal and remove all objects from the inner part. 13.5 Drum • Clean the drum with special product for stainless steel. Regularly examine the drum to prevent • Start a short programme for cotton at limescale and rust particles.

  • Page 26: Drain Pump

    26 www.aeg.com 13.7 Drain pump • The display shows an alarm code be- cause of the problem with water drain. Regularly examine the drain WARNING! pump and make sure that it is Disconnect the mains plug clean. from the mains socket.
  • Page 27 ENGLISH Remove fluff and objects from the pump. Make sure that the impeller of the pump can turn. If this does not oc- cur, contact the service centre. Clean the filter under the water tap and put it back in the pump into the special guides.

  • Page 28: Troubleshooting

    28 www.aeg.com Remove the inlet hose behind the appliance. Clean the filter in the valve with a stiff brush or a towel. Install again the inlet hose. Make sure that the couplings are tight to prevent leakages. Open the water tap.
  • Page 29 ENGLISH • • - The appliance does not drain - The anti-flood device is on. the water. WARNING! • - The appliance door is open or Deactivate the appliance before not closed correctly. you do the checks. Problem Possible cause Possible solution The appliance The water tap is closed.
  • Page 30 30 www.aeg.com Problem Possible cause Possible solution The filter of the drain Clean the filter of the drain pump is blocked. pump. Refer to 'Care and clean- ing'. Balance problems with Adjust manually the items in the the laundry load.
  • Page 31 ENGLISH Problem Possible cause Possible solution The cycle is longer An unbalanced laundry This is a normal behaviour of than the time dis- load increases the dura- the appliance. played. tion time. The washing re- The detergent you used Increase the detergent quantity sults are not satis- was not sufficient or cor- or use a different one.

  • Page 32: Installation

    32 www.aeg.com 15. INSTALLATION 15.1 Fixing plate kit If you install the appliance on a plinth, secure the appliance in the fixing plates. (4055171146) Follow the instructions supplied with the kit. Available from your authorized dealer. 15.2 Unpacking Use the gloves. Remove the external film.
  • Page 33 ENGLISH Open the door. Remove the poly- styrene piece from the door seal and all the items from the drum. Put one of the polystyrene packag- ing elements on the floor behind the appliance. Carefully put down the appliance with the rear side on it.

  • Page 34: Positioning And Levelling

    34 www.aeg.com Remove the three bolts. Use the key supplied with the appliance. Pull out the plastic spacers. Put the plastic caps in the holes. You can find these caps in the user manual bag. WARNING! We recommend that you keep...
  • Page 35 ENGLISH • The appliance must be level and sta- ble. CAUTION! Installation on suspended Do not put cardboard, wood or flooring equivalent materials below the appliance feet to adjust the level. Suspended wooden floors are particular- ly susceptible to vibration. To help pre- Make sure that there is sufficient vent vibration we recommend you place access after the installation for...

  • Page 36: Water Drainage

    36 www.aeg.com • Connect the water inlet hose to the cold water tap with 3/4 thread. CAUTION! Make sure that there are no leaks from the couplings. Do not use an extension hose if the inlet hose is too short. Con- tact the service centre for the re- placement of the inlet hose.
  • Page 37 ENGLISH • On the edge of a sink. • Make sure that the plastic guide can- not move when the appliance drains. Attach the guide to the water tap or the wall. • To a stand pipe with vent-hole. Refer to the illustration. Directly into a drain pipe at a height of not less than 60 cm (23.6”) and not more than 100 cm (39.3”).

  • Page 38: Environment Concerns

    38 www.aeg.com • Directly to a built-in drain pipe in the room wall and tighten it with a clip. You can extend the drain hose to maximum 400 cm. Contact the service centre for the other drain hose and the extension.
  • Page 39 ENGLISH...
  • Page 40 www.aeg.com/shop...

Table of Contents