Miele Novotronic T 560 C Operating Instructions Manual page 18

Problem solving guide
To open the door in the event of
power failure
Water droplets appear at the upper
edge of the drum aperture.
A double filter system with double seal
prevents fluff from being deposited in
the heat exchanger.
This means that the heat exchanger
does not need to be cleaned so often.
The double seal may lead to the build-
up of condensate. Laundry being
removed from the machine may come
into contact with these water droplets.
They will, however, dry off in a matter of
minutes.
The light ring do not illuminate
The bulb has gone. Please contact
your Miele Costume Service Dept. for
advice on how to change the bulb.
The functioning of the machine is no
way affected.
18
The "Anti-crease" indicator lamp in
the sequence indicator display starts
flashing.
Release the "On/Off" button and
then press it in again.
Press the"Start" button.
If the indicator lamp starts flashing
again, this indicates a fault in the ma-
chine. Please then contact your Miele
Dealer or the Miele Service Dept.
The drum door opens during the
drying cycle.
The machine has overheated. The tem-
perature limiter opens the drum door
and thus causes the machine to switch
off automatically.
Possible reasons for overheating:
The fluff filters in the door and in the
door opening are clogged.
The heat exchanger is blocked.
Before restarting the programme, pro-
ceed as follows:
Clean the affected part of the ma-
chine.
Press the "Start" button.
Should the drum door open again, this
must be due to a technical fault and
the Service Dept. should be contacted.