Fujitsu SPARC Enterprise T2000 Product Notes page 18

Specific Issues for the SPARC Enterprise T2000 Server (3 of 6)
TABLE 1
CR ID Description
6343294 When a Solaris PSH error is detected and reported,
the following erroneous message (in addition to the
correct message) might be reported:
msg = warning: bad proto frame implies
corrupt/lost msg(s)
6342192 The server does not answer incoming calls on the
ALOM CMT serial management port.
6347456 SunVTS memory tests, in rare cases, might log a
warning message similar to the following when the
ECC Error Monitor (errmon) option is enabled:
WARNING: software error encountered
while processing /ar/fm/fmd/errlog
Additional-Information: end-offile
reached
6344888 The system might generate erroneous fault messages
with the following message IDs:
SUN4-8000-ER
SUN4-8000-OY
SUN4-8000-75
SUN4-8000-D4
6368136 The ALOM showlogs -p p command displays a
lot of data and could slow down the ALOM CLI.
6368944 At the ok prompt, you can only enter text up to 114
characters.
6380987 When a grounding wire is connected to the
grounding pin on the rear of the chassis, it is not
possible to change rear blower without removing the
ground connection.
6381064 The system cannot boot if a Sun type-7 keyboard is
plugged into one of the front USB ports.
6405137 Intermittently, upon a system host power-on or reset,
the system powers down with the following
message:
HV Abort: JBI Error (22) - PowerDown
6408619 The server fails to boot from a Linux tftp boot server
on the network.
10 SPARC Enterprise T2000 Server Product Notes • May 2010
Workaround
Disregard the erroneous message.
Do not connect a modem to the ALOM CMT
serial port.
Do not enable the errmon option. The errmon
option is disabled by default.
Make sure that the following line is in the
/etc/system file:
set pcie:pcie_aer_ce_mask=0x2001
See "Mandatory /etc/system File Entry" on
page 3.
To display the persistent log, use the following
command instead:
showlogs -e x
where x specifies the number of lines (most
recent log entries) to be displayed.
Do not attempt to enter more than 114 characters
at the ok prompt.
If you need to replace the rear blower unit, and
there is a grounding wire connected, remove the
grounding wire to access the blower unit.
Do not plug a type-7 keyboard into any of the
front USB ports. Instead, use a different kind of
keyboard, or use the rear USB ports.
Disregard this message. If the server hangs, reset
the server from the system console.
Use a Solaris OS tftp boot server.