Advertisement
Installing the Camlock
NOTE: For this procedure, refer to Detail "B" of FIGURE 1.
1. Remove old camlock assembly from upper cane handle.
2. Slide camlock assembly onto bottom of upper cane handle ensuring small tab on top
front of camlock housing snaps into small notch on the bottom front of cane handle.
3. Operate cam lever up and down to ensure it opens and closes properly.
Cam Handle
Cam
Large
Lever
Tab
(Rear)
Cam Handle
Cam Lock
Housing
Reassembling the Quad Cane
NOTE: For this procedure, refer to FIGURE 2.
1. Raise cam lever before installing upper
cane handle onto base.
2. Re‐install cane handle with new
camlock assembly onto cane base.
3. Push cam lever down.
NOTE: This will engage the large tab on
bottom rear of cam lever into large notch on rear
of cane handle.
4. Test cane to ensure that cane and
camlock assembly are properly
secured, i.e., no rattle or looseness of
the cane base and upper cane handle.
Quad Cane Camlock Replacement Kit
Cut out
DETAIL "A" -
ASSEMBLING
CAMLOCK
Recess
Cam
Lock
Small
Housing
Tab
UNLOCK
LOCK
Rear of Cam Handle
Large Tab
Cut out
FIGURE 1 Assembling the Camlock
www.invacare.com
Invacare Corporation
USA
Canada
One Invacare Way
570 Matheson Blvd E Unit 8
Elyria, Ohio USA
Mississauga Ontario
44036-2125
L4Z 4G4 Canada
800-333-6900
800-668-5324
2
DETAIL "B" -
INSTALLING
CAMLOCK
Front
Small Notch on front
of Cane Handle.
(Not Shown).
Small Tab
Camlock
Assembly
Cam Lever
NOTE: Raise Cam Lever before
installing Camlock Assembly
Upper Cane
Camlock Assembly
Handle
Base
NOTE: Push Cam Lever down after
re‐installing upper cane handle to base.
FIGURE 2 Reassembling the Quad Cane
Invacare, Yes, you can. and the Medallion
Design are registered trademarks of
Invacare Corporation.
©2006 Invacare Corporation
Part No 1055947
Rev B - 10/12/06
Upper Cane
Handle
Rear
Large
Notch
UNLOCK
LOCK
Cam
Lever
Part No 1055947
Advertisement
