Adjusting Anti-Tippers - Invacare 1036900 Assembly, Installation And Operating Instructions

8. Measure the distance between the bottom of the anti‐tipper wheels and the
ground/floor.
• Non‐Adjustable Height Anti‐Tipper Assemblies: If the distance between the bottom of
the anti‐tipper wheels and the ground/floor is not 1½ to 2‐inches, call Invacare
Technical Support at the number listed on the back page.
• Adjustable Height Anti‐Tipper Assemblies: If the distance between the bottom of
anti‐tipper wheels and the ground/floor is not 1½ to 2‐inches, adjust anti‐tippers. Refer
to Adjusting Anti‐Tippers on page 3.
*NOTE: Non‐adjustable
anti‐tipper shown.

Adjusting Anti-Tippers

NOTE: For this procedure, refer to FIGURE 2.
NOTE: A 1½ to 2‐inch clearance between the bottom of the anti‐tipper wheels and the ground/floor
MUST be maintained at all times.
1. Press the release buttons near the wheeled portion of the anti‐tipper and slide the
anti‐tipper up or down to achieve the 1½ to 2‐inch clearance.
2. Check to make sure that the release buttons are fully engaged in the adjustment holes.
WARNINGEnsure both anti-tippers are adjusted to the same height.
Part No 1086188
Lower
Anti-Rattle
Frame
(if provided)
Tube
(STEP 4)
*Anti-Tipper
Spring Button(s)
FIGURE 1 Installing Anti-Tippers
WARNING
1½ inches
FIGURE 2 Adjusting Anti-Tippers
3
Locking Hole (9/32-inch Diameter)
(STEPS 2,3)
15/16-inch
(STEP 3)
Plug Button or End
Cap (End cap not
shown) (STEP 1)
(STEP 5)
Release Buttons
2 inches
Anti-tippers