Table of Contents
Advertisement
Note:
These services must be contracted
together with your local operator.
Follow-me
The Follow-me service allows automatic
transference of received calls to another
telephone number. To activate follow-me,
proceed in the following way:
Lift the handset
Press the FOLLOW-ME key (position
7 on page 3)
Dial the telephone number to where
:
you want to make the call transference
Press the FOLLOW-ME key (position
7 on page 3)
To deactivate the follow-me service, press
the Follow me key
twice.
Call Waiting
If during a conversation you hear the
warning tone of a waiting call, you can
answer it by pressing the Call Waiting key.
. The first call will be retained.
When you wish to pass from one call to
another, press the Call Waiting key
again. The procedure can be repeated as
many times as you wish. To finish the
communication in progress and continue
with the other, press the Release Call key
. To finish the last communication, just
hung up.
Consultation
When, during a conversation, you wish to
make a consultation, press the FLASH key
to get the dial tone again. Dial the
desired number to set up the consultation
communication.
Once the consultation is made, press the
Call Waiting key
to change between the
calls or the Release Call key
the
communication
in
continue with the other one.
Conference
The conference service allows the setting
up of communication among three people.
Firstly set up two communications by using
the
procedures
of
Call
Consultation described earlier. Then press
the
Conference
key
simultaneous communication among the
three people.
Mailbox
The Mailbox service allows messages to be
stored so that the user can hear them later.
This service has an access code that can
be programmed in the Mailbox key (see
the item Mailbox on page 8).
Alarm
The alarm sounds daily at the programmed
time and shows on the display, when
alarming, the message "ALARM", the time
and the date. The alarm stops ringing after
40 seconds or after lifting the handset.
If the telephone is off hook at the
programmed time, there will be no audio
signaling, only the message on the display.
The alarm rings at a single volume,
independent
of
the
programming.
The melody of the ring is the same
programmed for the call signaling and the
ring rhythm of the alarm (1 second followed
by a 3 second pause) is distinct from the
normal rhythm generated by central office
exchange.
15
to finish
progress
and
Waiting
or
to
establish
ring
volume
- Quick Links:
- Setting the Ringer Volume
Hide quick links:
Advertisement
Table of Contents
