Wall-Mount Option - Linksys WET200 User Manual

Chapter 
Bridge, and push the stand upward until it snaps into
place. Repeat this step with the other stand.
Stand Installation
Proceed to "Chapter 6: Advanced Configuration, " for
directions on how to set up the Bridge.

Wall-Mount Option

1. On the Bridge's back panel are two crisscross wall-
mount slots.
73 mm
Wall-Mount Slots on Bridge's Back Panel
2. Determine where you want to mount the Bridge, and
install two screws that are 73 mm apart.
3. Line up the Bridge so that the wall-mount slots line up
with the two screws.
4. Place the wall-mount slots over the screws and slide
the Bridge down until the screws fit snugly into the
wall-mount slots.
Proceed to "Chapter 6: Advanced Configuration, " for
directions on how to set up the Bridge..
Wreless-G Busness Ethernet Brdge
Large Prongs
Installation