Pantech Crossover User Manual page 66

Connectivity
This chapter introduces useful tips on how to connect to the
network available that enables applications of Crossover to
run.
Using a Wi-Fi network
Connecting to a Wi-Fi network
1. Tap Settings from the applications menu.
2. Tap Wireless & networks > Wi-Fi settings.
3. Tap Wi-Fi to activate the technology.
4. Select and tap a network. You should enter the password
if the network is secured.
network.
5. Tap Connect. Once the network is remembered, Crossover
will automatically connect to it when in range.
Activating Wi-FI
Note The icon next to each network indicates the strength of the
signal. For example, indicates the signal is poor while
the signal is strong.
indicates a secured Wi-Fi
Connecting to a Wi-Fi
network
indicates
About network notifications
You are informed by default when a Wi-Fi network is available
around you. The message
network is available. Tap Network notification in the Wi-Fi
settings if you do not want to be informed the availability of the
network.
Setting Wi-Fi networks
1. Tap Settings from the applications menu.
2. Tap Wireless & networks > Wi-Fi settings.
3. Tap Wi-Fi to activate the technology.
4. Tap Automatic connection if you want Crossover to
connect to AT&T Wi-Fi network automatically.
5. Tap WPS connection and tap Button connection or
PIN connection if you want to establish a new wireless
connection using the Wi-Fi Protected Setup (WPS). You
should press WPS button or enter PIN on your Wi-Fi access
point within two minutes.
Using the Easy Setting
1. Tap on the top of the home screen and drag it down, or
press n in idle mode and tap Notifications.
2. Tap in Easy Setting. The icon turns red when the function
is on.
Searching for Wi-Fi networks
1. Tap Settings from the applications menu.
2. Tap Wireless & networks > Wi-Fi settings.
3. Tap Wi-Fi to activate the technology. Crossover scans
networks automatically every six seconds. The newly found
networks appear on the bottom of the list.
66
in the status bar indicates a