Kenwood DPX-MP4090 Instruction Manual page 36

Troubleshooting Guide
The messages shown below display your
systems condition.
Eject: No disc magazine has been loaded in
the changer. The disc magazine is not
completely loaded.
➪ Load the disc magazine properly.
No CD in the unit.
➪ Insert the CD.
No Disc: No disc has been loaded in the disc
magazine.
➪ Load a disc into the disc magazine.
TOC Error: No disc has been loaded in the disc
magazine.
➪ Load a disc into the disc magazine.
The CD is quite dirty. The CD is upside-
down. The CD is scratched a lot.
➪ Clean the CD and load it correctly.
Error 05: The CD is upside-down.
➪ Load the CD correctly.
Blank: Nothing has been recorded on the MD.
No Track: No tracks are recorded on the MD,
although it has a title.
Error 15: Media was played that doesn't have data
recorded that the unit can play.
➪ Use media that has data recorded that
the unit can play.
Error 77: The unit is malfunctioning for some reason.
➪ Press the reset button on the unit. If the
"E-77" code does not disappear, consult
your nearest service center.
Error 99: The unit is malfunctioning for some reason.
➪ Press the reset button on the unit. If the
"E-99" code does not disappear, consult
your nearest service center.
Hold: The protective circuit in the unit activates
when the temperature inside the
automatic disc changer exceeds 60°C
(140°F), stopping all operation.
➪ Cool down the unit by opening
the windows or turning on the air
conditioner. As the temperature falls
below 60°C (140°F), the disc will start
playing again.
36
|
English
No Name: Attempted to display DNPS during the CD
play having no disc names preset.
Load: Discs are being exchanged in the Disc
changer.
Reading: The unit is reading the data on the disc.
IN (Blink): The CD player section is not operating
properly.
➪ Reinsert the CD. If the CD cannot be
ejected or the display continues to flash
even when the CD has been properly
reinserted, please switch off the power
and consult your nearest service center.
IN (Blink): The tape player section is not operating
properly.
➪ Reinsert the Tape. If the tape cannot be
ejected or the display continues to flash
even when the tape has been properly
reinserted, please switch off the power
and consult your nearest service center.
Protect: The speaker wire has a short-circuit or
touches the chassis of the vehicle, and
then the protection function is activated.
➪ Wire or insulate the speaker cable
properly and press the reset button.
N/A File: An Audio file is played with a format that
this unit can't support.
➪ ----
Copy PRO: A copy-protected file is played.
➪ ----