Turbo LED Connector: Pins 8 and 18
There is no turbo/deturbo function on the board. The Turbo
LED on the control panel will always be On when attached to
this connector.
Reset Switch: Pins 9 and 19
The reset switch allows the user to reset the system without
turning the main power switch off and then on again.
Orientation is not required when making a connection to this
header.
Hard Disk Drive LED Connector: Pins 10 and 20
This connector connects to the hard drive activity LED on
control panel. This LED will flash when the HDD is being
accessed.
FAN1: CPU Fan Power Connector
FAN1 is a 3-pin header for the CPU fan. The fan must be a 12V fan.
3
2
1
Pin #
Signal Name
1
2
3
Rotation detection
I815E User' s Manual
INSTALLATIONS
Pin #
Signal Name
8
18
Ground
Pin #
Signal Name
10
Ground
20
Ground
+12V
5V
5V
17