Finalizing Cd-R & Cd-Rw Discs; Unfinalizing Cd-Rw Discs - Philips CDR 760 Instructions For Use Manual

Start analogue recording
1 To start recording, press PLAY on the CD recorder and
immediately start the source.
➜
lights continuously. The track number and
RECORD
recording time used appear on the display.
• To record a 3-second silence at the beginning of a track,
press PAUSE.
• To check the (remaining) recording time, press Display.
(This can also be done during the recording.)
2 To stop recording, press STOP on the CD recorder.
➜
will go out.
RECORD
• To interrupt recording, press PAUSE.
➜
will start to flash. Resume at step 1.
RECORD
After recording the display will show UPDATE for several
seconds.
Note: With on, the recorder will stop
AUTO TRACK
automatically after 20 seconds silence. With
off, the mode is disabled.
TRACK AUTO STOP
Finalizing CD-R & CD-RW discs
Finalizing is a simple procedure that is necessary in order to
play the discs on a regular (non-recording) CD player.
Note: Finalizing prevents any further recording on a CD-R. A
finalized CD-RW must be unfinalized to allow further
recording or erasure of tracks.
1 Make sure the disc is absolutely free of scratches and dust
particles.
2 With the recorder stopped press FINALIZE and then within
3 seconds press RECORD.
DIG AUTO TRACK
ALOG
PROG
RECORDABLE
➜ The approximate finalization time will appear in the
display.
RECORD
The display counts down through the finalization. On
AUTO
completion, the total number of tracks and the total time
recorded will appear on the display.
For CD-R
CD RECORDABLE
display. For CD-RW no change will be seen on the
display.
Finalizing will last at least 2 minutes.
Note: During finalization, the CD recorder will not accept
operating commands.

Unfinalizing CD-RW discs

For CD-RW discs only.
If you want to make more recordings (or to erase tracks) on a
finalized disc you must unfinalize it first. The Table of
Contents (TOC) on the disc will be removed.
To unfinalize:
1 Press ERASE twice.
➜ On the display, TOC and
DIG AUTO TRACK
ALOG
PROG
RECORDABLE
2 Press RECORD within 3 seconds.
➜ TOC and
ERASE
Note: This will take approximately 1 minute.
RECORDING
REPEAT 1 TOTAL REM TRACK TIME
L
& lights up.
FINALIZE
will change to on the
CD
will flash.
ERASE
REPEAT 1 TOTAL REM TRACK TIME
L
light up continuously during erasure.
CD SYNC
RECORD
FINALIZE
ERASE
COPY
CD SYNC
RECORD
FINALIZE
ERASE
COPY
15