Switching The Display; Adjusting The Brightness Of The Front Display; Using The Sleep Time (Remote Controller Only); Temporarily Changing The Speaker Output Levels - Integra DTR-6.2 Instruction Manual

Enjoying music or videos with the DTR-6.2
Display Dimmer
Standby/On
Standby
Power
On O f f
Display
Phones Audio
Selector DVD

Switching the display

While listening to or watching an input source, you can display the
information regarding the type of source and signal being input by
pressing the
button on the DTR-6.2 or the DISPLAY button on the remote
controller.
DTR-6.2
Display
When an input source other than FM or AM is selected:
Input + volume
Program format*
Input +
Listening mode
or Multi Ch
* If the input signal does not have a program format, then this will
be skipped.
When FM or AM is selected as the input source:
FM/AM frequency +
Preset no.
FM/AM +
Listening mode

Adjusting the brightness of the front display

You can adjust the brightness of the front display of the DTR-6.2
with DIMMER button on the remote controller or Dimmer button
on the DTR-6.2 front panel.
DTR-6.2
Dimmer
30
Jog dial
CH Level
Rec Out Zone 2 Zone 2 Level CH Level
DSP/ Mode ADJ Setup
Return
Push To Enter
Dimmer FM Mode Preset Memory Tuning Preset Smart Scan Navigator
Bass
Video 1 Video 2 Video 3 Video 4 Tape FM AM Phono CD
VCR 1 VCR 2
Remote controller
Remote controller
SLEEP
Master Volume
CH SEL
Treble
DISPLAY

Using the sleep time (remote controller only)

The SLEEP button enables you to set the DTR-6.2 to turn off
automatically after a specified time period. If you press it once, the
DTR-6.2 will turn off after 90 minutes. Each time it is pressed
thereafter, the remaining time until the DTR-6.2 turns off decreases
by 10 minutes. While, the sleep function is enabled, you can press
the SLEEP button to see how much time is left. To cancel the sleep
function, press the SLEEP button when the time displayed is less
than 10 minutes.
If you are using the remote zone (Zone 2), it will turn off at the same
time as the main zone. If you want to set the sleep function for Zone
2 only, set the sleep function with main zone turned on and then put
the main zone into the standby state.

Temporarily changing the speaker output levels

To change the individual speaker volumes temporarily, follow the
procedure given below. Each channel can be set between –12 to +12
decibels. Note that the calibration settings will return to the original
settings when the DTR-6.2 is put in standby.
1. Press the CH Level button and select
the desired speaker.
2. Turn the jog dial to adjust the
volume level.
ch
When using the remote controller:
1. Press the RCVR MODE button.
2. Press the CH SEL button and select
the desired speaker.
3. Press the LEVEL
adjust the volume level.
Notes:
• You cannot select a speaker if the Speaker Config sub-menu of
the Speaker Setup is set to No or None.
• If the speaker level is set to +1 dB or higher, the maximum level
indicated on the display will change if you raise the volume
level.
• When you press the TEST button after you set the level, the
current level will be used as the value set via the test tone.
MUTING
LEVEL
DIMMER
HOME THEATER CONTROLLER
RC-441M
Remote controller
or button to
CH Level
DSP / Mode ADJ
Push To Enter