Panasonic SC-HT07 Operating Instructions Manual page 5

3UPPLIED
ACCESSORIES

!DJUST THE SPEAKER HEIGHT
EG 7ITH THE STAND ATTACHED
TO THE LOWER REAR OF THE
SPEAKER
3TOPPER SCREW
3CREW TO STOP MOUNTING
PLATE FROM MOVING OR
SLIDING BELOW THIS POINT

#ONNECT THE SPEAKER CABLES
#OPPER
3ILVER

&ASTEN THE SPEAKER CABLE TO THE BASE
0REVENTING THE SPEAKERS FROM FALLING OVER
!TTACH SCREW EYES NOT INCLUDED TO SECURE THE SPEAKERS TO A WALL
DIAGRAM ON THE RIGHT 
x /BTAIN THE SCREWS APPROPRIATE TO THE WALLS AND PILLARS TO WHICH THE THEY
ARE GOING TO BE FASTENED
x #ONSULT WITH A QUALIFIED HOUSING CONTRACTOR CONCERNING THE APPROPRIATE
PROCEDURE WHEN ATTACHING TO A CONCRETE WALL OR A SURFACE THAT MAY NOT
HAVE STRONG ENOUGH SUPPORT )MPROPER INSTALLATION MAY RESULT IN
DAMAGE TO THE WALL OR SPEAKERS
3PEAKER STANDS
X 
3TAND BASES
X 

,OOSEN THE ATTACHED SPEAKER MOUNTING PLATE SCREW UNTIL THE
ATTACHED SPEAKER IS SLIGHTLY LOOSE AND ADJUSTABLE
x "E CAREFUL NOT TO LOOSEN THE SCREW TOO MUCH OR THE SPEAKER MAY
DETACH AND FALL

!DJUST THE POSITION OF THE PIPE
x !FTER ADJUSTING THE HEIGHT TIGHTEN THE SCREW ON THE MOUNTING PLATE
SECURELY

#ONNECT THE SPEAKER CABLES

0RESS THE SPEAKER CABLE INTO THE GROOVE
)F THERE IS ANY EXCESS CABLE THREAD IT FROM THE OPENING NEAR THE TOP OF
THE PIPE WHILE PULLING IT FROM THE BOTTOM OF THE BASE

0RESS THE SPEAKER CABLE AND THREAD BETWEEN THE HOOKS

&IT THE SPEAKER CABLE INTO THE BASE COVER GROOVE AS FAR AS
POSSIBLE
3CREWS LARGE AND SMALL
X 
X 
7ALL