InSinkErator C1300 Owner's Manual page 2

WHAT YOU SHOULD KNOW BEFORE YOU BEGIN
■ ■
For your satisfaction and safety, read all instructions, cautions, warnings and dangers before installing
or using this instant hot water dispenser.
■ ■
Make sure that all electrical wiring and connections conform to local codes.
■ ■
A standard 115-volt grounded electrical outlet is required for the dispenser's electrical power.
■ ■
The wall outlet powering the dispenser must have power supplied to it continuously.
■ ■
To ensure proper operation, this unit is not intended to be flushed with chlorine. If you suspect elevated
levels of chlorine in the water, it is recommended to use our water filtration system.
■ ■
Moving parts inside the tank causing a rattling noise is normal.
Equipment Required:
■
Drill
■
Compression fitting,
T-fitting or saddle valve
■
Adjustable wrench
Equipment You May Need:
■ ■
Anchors for drywall
■ ■
Hole saw
C1300
H778
2
Food Service Equipment
Instant Hot Water Dispenser
Installation, Care & Use Manual
IN THIS PACKAGE
Rubber O-Ring
Hex Nut
4" Extension Fiber Gasket
■
Phillips and flat blade screwdrivers
■
Pencil
■
Tape Measure
■
Level
■ ■
Basin wrench
■ ■
Hole punch
Semi-circular
Hex Tool
Mounting Plate
Mounting Washer Mounting Screw
3/4" Screws (2)
3/4" Screws (2)