Installation Of New Disposer - InSinkErator Evolution Excel Installation Manual

Installation of new disposer:

10
C
Evenly apply 1/2" thick rope of
plumber's putty around flange
(C).
13
I
Optional
Place a weight such as the dis-
poser on the sink flange to hold
it in place. Use a towel to prevent
scratching sink. Pull snap ring
open and press firmly until it
snaps into place.
C A U T I O N
CLEAN DRAIN LINE
BEFORE INSTALLING DISPOSER
Failure to clean sink drain line may result in drain
line blockage. With drain auger, clear all hardened
waste material in horizontal drain line.
11
C
Press flange (C) firmly into sink
drain. Remove excess putty.
14
Tighten 1 1/2" screws (G) evenly
and firmly against backup flange.
Use shorter 1 1/8" screws (H) if
sink is more than 3/8" thick.
5
12
E
Insert fiber gasket (D), backup
flange (E) and mounting ring (F).
Hold in place while inserting snap
ring (I).
< 3/8"
E
F
15
1-1/2"
G
> 3/8"
J
E
F
1-1/8"
H
*CAUTION: DISHWASHER
CONNECTION ONLY If you do not
need to attach the dishwasher, go to
step 17. Turn disposer (J) onto side
and insert screwdriver into dish-
washer inlet.
C
D
G
F
Stop
&
*
!
Read