Standby/Hibernation Function; Battery Indicator - Panasonic CF-51 Series Reference Manual

Dealing with Problems (Advanced)

Standby/Hibernation Function

Unable to enter standby or hibernation
mode
Unable to automatically enter standby
or hibernation mode
The computer does not resume

Battery Indicator

The red indicator lights
The red indicator blinks
If a USB device is connected to the computer (note: only for some USB
devices), remove the USB device temporarily. If the problem persists, restart
the computer.
It may take one or two minutes to enter the standby or hibernation mode.
The computer may not enter the standby mode while the computer is communi-
cating via the modem.
If there is a disc in the CD/DVD drive that has been formatted using B's CLiP,
the computer will not enter standby or hibernation mode. Remove the disc.
If a peripheral is connected to the computer, disconnect the device.
When the internal LCD is closed, the computer may not enter standby or
hibernation mode. In order to activate standby or hibernation automatically
while using the computer with the internal LCD closed, set the [Touch Pad] to
[Disable] in [Main] menu of the Setup Utility.
Did you press the power switch and hold it for four seconds or more? If you
press the power switch and hold it for four seconds or more, the power will be
turned off forcibly. In this case, all unsaved data will be lost.
Did you disconnect the AC adaptor or the battery pack while the computer was
in standby mode?
If the computer's power supply is disconnected while the computer is in standby
mode, the unsaved data will be lost.
The battery level is very low (the charge is approx. 9% or less).
Connect the AC adaptor. You can use the computer when the battery indicator
light is orange. If you do not have an AC adaptor, save your data and power off
your computer. After replacing the battery pack with a fully charged one, turn
your computer on.
Quickly save your data and power off your computer. Remove the battery pack
and disconnect the AC adaptor, then connect them again. If the problem
persists, contact Panasonic Technical Support. The battery pack or charging
circuit may be defective.
100