Sp Distance; Sp Level - Kenwood VR-4900 Connection And Setup Manual

Chapter Two : Setting Up PowerTouch
c. If you set your left and right front speakers to Lrg
and want to send bass to the subwoofer in all Listen
modes, touch until "On" appears above the
button. All modes SW Re-Mix mixes some of the
bass from your All the speakers back into your
subwoofer.
If you set your left and right front speakers to Nml,
SW Re-Mix does not function.
d. Touch to save your settings.
e. Touch to move to the next speaker setting or
touch to return to the Setup Surround menu.
If your front speakers are set to Nml, you can only set your
36
center and surround speakers to Nml (or Off).
If you turn off the subwoofer, your front speakers are auto-
matically set to Lrg. You may not set them to Nml.

SP Distance

1. Measure the distance from each speaker to the seat you
most often use and note it below:
Speaker Distance (ft or m)
left front
center
right front
right surround
left surround
subwoofer
2. If you are not already there, touch
the Setup Surround menu to open the Speaker Distance
menu:
3. Touch or to set the distance for the left front
speaker.
4. Touch or to select the next speaker.
5. Repeat steps 3 and 4 for each speaker.
6. Touch to move to the next speaker setting or touch
to return to the Setup Surround menu.

SP Level

In this step you will use your ears to balance the volume level
of all the system's speakers except the subwoofer for your room
and listening position. (To set the subwoofer level, see "Set-
ting the Subwoofer Level" on page 37.) When all the speak-
ers are set at the same volume level, your system will create a
more realistic, spacious surround sound environment.
1. Eliminate as many external noise sources as possible.
2. Sit in the place where you and your guests are most likely
to sit while watching movies or listening to music.
3. Turn the receiver's master volume up to -25dB. (For great-
est accuracy, the level-setting procedure should be per-
formed at a moderately loud listening level.)
4. If you are not already there, touch
on
the Setup Surround menu to open the Speaker Level
menu:
5. Touch until the Test Tone display reads "Manu".
6. Test noise will play from the left front speaker. Care-
fully listen to the volume level of the noise.
on