User Interface; Programming Commands - Chamberlain PPWR Quick Manual

USER INTERFACE

The PPWR user interface consists of a 22 character by 5 line LCD display, 3 "soft keys", Down/Up arrows and a numeric keypad.
Scroll Indicator
If more than 3 options exist, a scroll indicator appears on the
left margin of lines 2, 3, and 4. The scroll indicator shows the
relative position within the list.
Line 1:
Menu and function mode.
Lines 2, 3, and 4:
Menu selections and data.
Line 5:
Soft key function modes.
Backup memory module indicator
®
(LiftMaster logo screen only)

PROGRAMMING COMMANDS

The table below describes the commands used to program the receiver.
MAIN MENU
26 BIT (DEFAULT)
WIEGAND FORMAT
30 BIT
31 BIT
34 BIT EVEN
34 BIT ODD
50 BIT
BUTTON 1 IS ON
BUTTON FILTER
BUTTON 2 IS ON
BUTTON 3 IS ON
PASS THRU (DEFAULT)
MODE SELECT
ADVANCED
PROGRAM
SECURITY TABLE
If advanced mode is
turned off this option is
LIST
disabled and will appear
as NOT AVAILABLE FOR
PASS THRU MODE
PIN
SETTINGS
DEALER INFO
FIRMWARE VERSION
BEEP
MEMORY
CONTRAST
LANGUAGE
FACTORY DEFAULT
COMMAND
CHANGE FC OUT
DELETE
DUPLICATE MEMORY
RESTORE MEMORY
DESCRIPTION
26 Bit Wiegand output code.
30 Bit Wiegand output code.
31 Bit Wiegand output code.
34 Bit EVEN Wiegand output code.
34 Bit ODD Wiegand output code.
50 Bit Wiegand output code.
Used when multiple receivers are within range of each other.
Passes all received remote control signals to the access system host controller.
Receiver only passes signals from a remote control with a previously programmed facility
code. All other signals are blocked.
Learn a facility code from any remote control in a batch that the PPWR will respond to.
Also used to resolve any conflicts in code translation.
Displays a list of all programmed facility codes showing facility code conflicts and facility
code changes. Options to delete or resolve facility code conflicts.
Change the 6-digit PIN number for the receiver.
Display and edit the dealer 10-digit phone number.
Displays the current firmware version.
Turn the audible feedback on or off.
Creates a memory backup. A memory module must be installed.
Restores a memory backup from a memory module. An indicator appears on the
®
LiftMaster logo screen if a backup memory module is installed.
NOTE: Content of memory module will over-write any information already stored in the
receiver memory.
Press Down or Up arrows to adjust LCD contrast.
Sets language: English (Default), Spanish, and French.
Reset receiver settings to factory default.
2
Antenna Connection
For the direct antenna or the
antenna extension kit.
Menu/Data selection shown
in inverse font.
LCD Screen
System programming and status
display.
"SOFT" Keys
Soft key functions are defined by
the label on line 5 of the display.
The functions change according
to the menu selection.
Down/Up Keys
For navigation in the menus.
Numeric Keypad
Numeric data is entered
through the numeric keypad.
Insert wiring