Cancelling A Programme; Reset; Interruption Of A Programme (Pause); Power Failure - Electrolux Diva Service Manual

4.3 Cancelling a programme

4.3.1

Reset

To cancel a programme that has already started:
1. Open the door carefully and press buttons S2 - S3
together for approximately 2 seconds.
2. The salt and rinse-aid LEDs light: the programme is
cancelled and the appliance is in pre-selection mode.
3. Set the new cycle.
4.3.2

Interruption of a programme (pause)

If the button [S0] is pressed the power supply is cut and the appliance switches off.
By pushing the button [S0] again, the appliance starts and the cycle starts from the point at which it was
interrupted.
If the door is opened, the appliance is powered (the power loads are deactivated).
The LED [LD..] of the selected programme and the Option LED remain lit.
Closing the door again the cycle restarts with a little delay from the point at which it was interrupted.
Important! If the appliance is switched off or if the door is opened for more than 30 seconds during
the drying phase, the cycle is considered to have been terminated after the regeneration phase; when
the appliance is switched on again, it returns to programme selection mode.

4.4 Power failure

The Power Failure function maintains the information relative to the cycle status even in the even of a power
outage; when the power supply is restored, the cycle resumes from the point at which it was interrupted.
If the power failure occurs during the drying phase, the cycle is considered to have been terminated after the
regeneration phase.
The power failure condition has been defined as follows:
During a Power Fail all the loads are off in order to enable, through the energy stored in the power
capacitor of the control board, to save the data in the EEPROM and therefore when the power is
restored the cycle can restart from the point at which it was interrupted.
SOI/TD PR 10/35 599 35 90-23