Navigation Radio; Sunroof - Hummer H2 2004 Getting To Know Manual

Navigation Radio (if equipped)
1
2
3
Set a station preset
• Turn the radio on by pressing the
VOL (power) button ("1" above).
• Push the BAND button ("2" above)
to select a desired band.
• Use either the control pad ("3" above)
or SEEK rocker to tune a station.
• Press and hold one of the six buttons
on the right side of the radio
("4" above) until you hear a beep or
see the station displayed next to the
button pushed.
Set your geographical area and
destination
• Turn the radio on by pressing the
VOL (power) button.
• Insert a map disc into the radio
CD slot.
• If a notice appears, use the control
pad to enter the highlighted NEXT
box by pushing the control pad.
• Push the DEST key.
Continue using the control pad for the
following steps:
• Highlight and enter the CHANGE box
on the right.
• Determine whether your geographical
area is selected. If it is not,
select/enter your area.
• Select/enter the ADDRESS box.
• Select/enter the name of the street.
(Note: Use the "Back" arrow to cor-
rect any misspellings.)
• If provided a list of streets, select the
correct street.
4
• Enter the street address.
• If provided a list of cities, select/enter
the proper one.
• Press the ADD button.
The system now calculates the fastest
route. Either press the map button in the
upper-right or use the control pad to
view/select alternate routes.
Note: See your Navigation System
manual for more information.
Sunroof (if equipped)
The sunroof controls are located in the
overhead console.
Close the sunroof
• Hold the front portion of the button
down ("A" above) until the sunroof
motor stops. The sunroof will tilt up
slightly to seal. This is normal.
Open sunroof to vent position
• Press the front portion of button when
the sunroof is closed.
9
A