Samsung SH07AS2 Service Manual page 16

7
8
9
10
11
12
Setting is not required if you must
a value which has a
Step 3 : Upon completion of the selection, check you made right selections.
Press the Mode Selection key,
The display part shows
Press the Mode Selection key,
The display part shows
Step 4 : Pressing the ON/OFF button (
When pressing the operation ON/OFF key with the direction of remote controller for unit, the sound ''Ding'' or ''Diriring'' is
heard and the OPERATION ICON(
pleted. (If the diriring sound isn't heard, try again pressing the ON/OFF button.)
Step 5 : Unit operation test-run
First, Remove the battery from the remote controller.
Second, Re-insert the battery into the remote controller.
Third, Press ON/OFF key with the direction of remote controller for set.
• Error Mode
1 st If all lamps of indoor unit are flickering, Plug out and plug in battery again and pressing ON/OFF key to retry.
2 nd If the unit is not working properly or all lamps are continuously flickering after setting the option code, see if the correct option code is
set up for it's model.
Samsung Electronics
7
8
9
10
11
12
default.
to set the display part to
.
to set the display part to
.
)
) lamp of the display is flickering at the same time, then the input of option is com-
Press button, then the default value is
Push the button to set the display panel to
Every time you push the button, the display panel reads
. . .
Push the button to set the display panel to
Every time you push the button, the display panel reads
. . .
Push the button to set the display panel to
Every time you push the button, the display panel reads
. . .
Push the button to set the display panel to
Every time you push the button, the display panel reads
. . .
Push the button to set the display panel to
Every time you push the button, the display panel reads
. . .
and check the display part.
and check the display part.
Set Up the Model Option
.
.
repeatedly.
.
repeatedly.
.
repeatedly.
.
repeatedly.
.
repeatedly.
15