Specifications - Ryobi RBV-2200 Operator's Manual

SERVICE
Servicing requires extreme care and knowledge and
should be performed only by a qualified service technician.
For service we suggest you return the product to your
nearest AUTHORISED SERVICE CENTRE for repair.
When servicing, use only identical replacement parts.
WARNING
Observe all normal safety precautions related to
avoiding electrical shock.
WARNING
To avoid serious personal injury, do not attempt
to use this product until you read thoroughly
and understand completely the operator's
manual. Save this operator's manual and review
frequently for continuing safe operation and
instructing others who may use this product.
WARNING
The operation of any power tool can result in
foreign objects being thrown into your eyes, which
can result in severe eye damage. Before beginning
power tool operation, always wear safety goggles
or safety glasses with side shields and a full face
shield when needed. We recommend Wide Vision
Safety Mask for use over eyeglasses or standard
safety glasses with side shields. Always use eye
protection.
SAVE THESE INSTRUCTIONS.

SPECIFICATIONS

SPECIFICATIONS
Voltage
Power
Air velocity
Air volume
Mulching ratio
Dust bag capacity
Vibration level
SPECIFICATIONS
Voltage
Power
Air velocity
Air volume
Mulching ratio
Dust bag capacity
Vibration level
English
RBV-2200
220-240V~ 50 Hz
2,200 W
237 Km/h
16 m /min
3
10:1
45 L
< 2.5 m/s
2
RBV-2400VP
220-240V~ 50 Hz
2,400 W
185~237 Km/h
10~16 m /min
3
10:1
45 L
< 2.5 m/s
2
DESCRIPTION
1. Shoulder Strap
2. Rear Handle
3. On/Off Switch
4. Speed Control Dial (Model RBV-2400VP only)
5. Front Handle
6. Motor Housing
7. Nozzle
8. Guide Wheels
9. Patio Head (Model RBV-2400VP only)
A
10. Dust Bag
11. Blower / Vac Mode Selection Lever
12. Power Cable & Plug
13. Live Tool Indicator
14. Dust Bag Holder
ASSEMBLY
ATTACHING THE NOZZLE (Fig.2)
The nozzle(7) comes in two sections. Assemble the
■
sections by slotting them together as shown in Fig.2
Ensure the sections have clicked into place and are
aligned properly.
Fasten the sections together at the top and at the
bottom, with screws provided.
Slide the assembled nozzle into the motor housing(6).
■
With the latches at the top and at the bottom, lock the
nozzle in place.
ATTACHING AND REMOVING THE DUST
BAG(10) (Fig.3 & 4)
CAUTION
Do not use the Blower/Vac in the vacuum mode
without the dust bag(10) in place.
Latch the front of the dust bag holder(14) to the front
■
of the dust exhaust and then lift the dust bag handle
side until the dust bag holder secures to the housing.
see Fig.3
Hang the strap at the front of the dust bag to the
■
bottom of the nozzle. See Fig.4
When removing the dust bag, detach the strap from
■
nozzle first, then press the release on the dust bag
holder and gently dislodge the dust bag off the motor
housing.
SHOULDER STRAP(1) (Fig.3)
Attach the metal fixture of the shoulder strap to the
■
hole just in front of the ON/OFF switch.
Adjust the shoulder strap to a length comfortable for
■
your use.
4