Video - Sherwood R-807 Operating Instructions Manual

R-807 NETWORk AV RECEIVER
Problem
Sound is interrupted or there
is noise.
No sound is heard or there
is noise when software with
DTS is played back.
The left and right sounds are
unbalanced or reversed.
Recording cannot be carried
out.
A test tone is not produced
from the speakers.
A test tone is heard from a
different speaker than the
speaker displayed on the TV
screen.
No sound, or sound suddenly
ceases.

VIDEO

Symptom
No image appears on the TV.
Recording cannot be carried
out.
No picture or sound.
52
Check the output audio formats support system.
•
• Check that the speakers and equipment are connected securely.
•
Move your audio equipment away from the TV.
The plugs and jacks are dirty. Wipe them with a cloth slightly moistened with
•
alcohol.
•
Set the digital volume level of the system to full, or to the neutral position.
•
Ensure the main unit's settings are correct and/or the DTS signal out is on.
Refer to the instruction manual supplied with the DVD player.
• Ensure that the speakers and equipment are connected correctly and securely.
Adjust the sound level parameters using the Speaker Settings menu.
•
•
Ensure that the equipment is connected correctly.
•
Select the source equipment using the input buttons (See page 26).
• Audio input signals via HDMI IN and DIGITAL IN jacks cannot be recorded.
•
Copyright protection to prevent recording is contained in the sources. In this
case, you may not be able to record from the sources.
• The speaker cords may not be connected securely. Check to see if they are
connected securely and cannot be disconnected by pulling on them slightly.
• The speaker cords may have a short-circuit problem.
The speaker pattern set up is incorrect. Make sure that the speaker connections
•
and the speaker pattern match correctly.
• If you've made separate connections for audio, make sure you have assigned
the analog/digital jack(s) to the corresponding HDMI input for the component.
• Check the audio output settings of the source component.
•
If the component is a DVI device, use a separate connection for the audio.
•
Select the appropriate input using the input buttons.
•
Set your TV to the appropriate input mode.
•
Move your audio equipment away from the TV.
•
Assign the component video input correctly.
Make sure that cables are correctly and securely connected to equipment.
•
Check that the equipment is connected correctly.
•
•
Select the source equipment using the input buttons (See page 26).
• Video input signals via HDMI IN and COMPONENT VIDEO IN jacks cannot be
recorded.
•
Copyright protection to prevent recording is contained in the sources. In this
case, you may not be able to record from the sources.
•
If the problem still persists when connecting your HDMI component directly
to your monitor, consult the component or monitor manual or contact the
manufacturer for support.
Remedy
Remedy