Before You Start - Fisher & Paykel RB90S Installation Instructions And User Manual

Before placing food in the drawer
Clean the inside of the appliance with warm water and a little liquid detergent to remove
■ ■
manufacturing and transportation dust.
Ideally, allow the drawer to run empty overnight, or for at least 5 hours, to allow it to cool to the
■ ■
appropriate temperature before placing food inside.
The appliance may have an odour initially, but this will go when the compartment has cooled
■ ■
sufficiently.
Energy efficiency
For the most energy efficient use of your appliance:
Ensure your CoolDrawer has adequate ventilation as recommended in the installation instructions.
■ ■
Allow good clearances in front of air ducts within the CoolDrawer.
■ ■
Cool hot foods down before placing them in the CoolDrawer.
■ ■
Do not overfill the CoolDrawer.
■ ■
Keep door openings to a minimum.
■ ■
Select a temperature setting that isn't too cold.
■ ■
Check your door seals for leaks.
■ ■
If your appliance is turned off for any reason, wait 10 minutes before turning it back on. This will
allow the refrigeration system pressures to equalise before restarting.
The temperature of the drawer is accurately controlled and does not change with the
temperature or humidity of the surroundings; whether summer or winter.
Storage bins featuring humidity
control system (refer to page 13)
Humidity control buttons
(refer to pages 13 and 14)
Main storage tray

Before you start

Compact storage tray
Tall storage bin
Control panel (refer to page 6)
Fig. 1 Compartment layout
5