Miele T 8433 C Operating Instructions Manual page 16

How to dry correctly
E Start the programme
^ Press the Start/Stop button.
– The indicator light for the Start/Stop
button will then change from flashing
to being on constantly.
– The programme duration will appear
in the display.
– The Sequence indicator light for the
drying stage reached will come on.
Memory function (for Programme
selection)
The electronics will store in memory the
drying level and any extra options
selected for the current drying
programme.
The next time you chose that
programme, the indicator lights for
these settings will come on. You can
either accept these or change them by
pressing the appropriate button.
The memory function is deactivated if
the programme is cancelled. If the
buzzer has been selected, this
selection will be saved automatically,
whether or not the memory function has
been activated.
Before the end of a programme
There is a cooling down phase at the
end of the drying sequence (the Cool
air indicator light will come on). The
programme will not finish until the
cooling down phase has been
completed.
There is no cooling down phase at the
end of the Woollens handcare and
Smoothing programmes.
16
F Remove the laundry when the
programme has finished
The Anti-crease/Finish indicator light
will come on to indicate that the
programme has finished. The indicator
light for the drying stage reached
(depending on the programme
selected) will also come on.
^ Press the Door button.
^ Open the door.
^ Remove the laundry.
Check that all items have been
removed from the drum. If items are
left in the dryer, they could be
damaged by overdrying when the
dryer is next used.
^ Switch the dryer off by pressing the
l-On/0-Off button.
^ Clean the fluff filters.
^ Close the door.
^ Empty the condensed water
container (unless the dryer has been
connected for external drainage).
^ The condenser unit should be
checked and cleaned on a regular
basis.