Releasing The Bellows From The Front Panel; Removing The Door Safety Switch - GE WSSH300G Technical Service Manual

Releasing the bellows (door boot) from the
front panel:
The front of the bellows is installed over the lip of the
door opening in the front panel and held in place by a
spring loaded wire loop.
1. Open the loading door.
2. Using needle nose pliers, start where the spring
and wire are connected at the bottom of the
bellows and pull the wire out of the groove of the
bellows.
3. Pull the bellows off of the lip of the front panel.

Removing the door safety switch:

1. Disconnect the washer from the electrical supply.
2. Release the bellows from the front panel.
3. Remove the (2) screws holding the switch
assembly to the front panel.
31