Table of Contents
Advertisement
Backward
1. Move the levers to the center, unlocked position.
2. To go backward, look behind you and down as
you slowly pull the motion control levers rearward
(Figure 19).
Figure 19
To go straight, apply equal pressure to both motion
control levers (Figure 19).
To turn, release the pressure on the motion control
lever toward the direction you want to turn.
To stop, push the motion control levers to neutral.
Stopping the Machine
To stop the machine, move the motion control levers to
neutral and outward to the park position, disengage the
blade control switch, ensure the throttle is in the fast
position, and turn the ignition key to off. Remember to
remove the key from the ignition switch.
WARNING
Children or bystanders may be injured if they
move or attempt to operate the mower while it is
unattended.
Always remove the ignition key and move the
motion control levers outward to the park position
when leaving the machine unattended, even if just
for a few minutes.
Adjusting the Height of Cut
Height-of-cut is controlled by the lever located to the
right of the operating position (Figure 20).
G008953
19
2
Figure 20
1. Height-of-cut lever
2. Height-of-cut positions
1. Pull up and inward on the lever to move it to the
desired cutting position.
2. Once at the desired cutting position, slowly lower
the lever until it engages the position.
The transport position is the highest height-of-cut
position or cutting height 4.5 inch [115 mm] (Figure 20).
Positioning the Seat
1. Raise the seat and loosen the adjustment bolts just
enough that seat can move (Figure 21).
1
Figure 21
1. Adjustment bolt
2. Move the seat to the desired position and tighten
the bolts.
3
1
G014476
3. 4.5 inch (115 mm),
Transport position
G014477
Hide quick links:
Advertisement
Table of Contents
