AEG Electrolux LAVAMAT 74800 User Information page 20

Problem
Washing machine vi-
brates when operating
or is noisy.
Washing has not been
spun.
Water is leaking out un-
derneath the washing
machine.
Washing water is foam-
ing excessively. At the
end of the washing cy-
cle, the spin stops. OVER
DOSING indicator is lit.
E20 appears.
END indicator flashes
2x, at the same time an
acoustic signal sounds
2x.
(Problems with water
outflow.)
Conditioner not rinsed
in, w compartment for
additives is filled with
water.
20
Possible cause
Transport lock has not been
removed.
Screw feet not correctly ad-
justed.
Only a few large items of
washing in the drum.
Screw connection on the in-
let hose is leaking.
Drain hose is leaking.
Drain pump cover is not
closed properly.
Washing was caught in the
door.
Emergency drain hose is
leaking.
Probably too much deter-
gent has been used.
Kink in the drain hose.
Maximum pumping height
of 1m exceeded.
Drain pump is blocked.
With connection to sink
outlet: sink outlet is
blocked.
Conditioner insert in the
compartment for additives
is not correctly attached or
is blocked.
Remedy
Remove transport lock.
Adjust feet according to the
Installation and Connection
instructions.
Always load the drum as full
as possible. Mix large and
small items.
Tighten inlet hose.
Replace drain hose.
Close cover properly.
Load washing carefully for
the next wash.
Close off emergency drain
hose properly.
Dose detergent exactly as in-
structed by manufacturer.
Remove kink.
Please contact the Customer
Care Department.
Switch off appliance. Pull out
mains plug.
Clean drain pump. Remove
foreign bodies from pump
housing.
Clean out sink outlet.
Clean detergent dispenser
drawer, insert conditioner in-
sert firmly.