Interrupting A Programme/Adding Washing; Washing Cycle Complete/Removing The Washing; Overdosing - AEG Electrolux LAVAMAT 74800 User Information

Interrupting a programme/adding washing

Interrupting a programme
• A washing programme can be interrupted at any time by pressing the
START/PAUSE button. It is then re-started by pressing the START/
PAUSE button again.
• To stop the washing machine before the programme has ended, turn
the programme knob to OFF. Important! Be careful if there is water
in the appliance!
Adding washing
It is possible to add washing, as long as the DOOR light is lit green.
1. Press the START/PAUSE button. The door can be opened.
2. Shut the door and press the START/PAUSE button again. The pro-
gramme continues.

Washing cycle complete/Removing the washing

At the end of the programme, END lights up on the programme
progress display. The door can be opened as soon as the DOOR is lit
green.
1. Open the door and remove the washing.
2. Turn the programme knob to OFF.
3. Close the water tap.
4. After the wash, pull out the detergent dispenser drawer slightly to al-
low it to dry. Leave the door slightly open to air the inside of the wash-
ing machine.
If RINSE HOLD was selected:
After the rinse hold, END lights up on the programme progress display.
The water must first be drained:
– Either turn the programme knob to OFF, then to DRAIN and press the
START/PAUSE button (the water is drained without spinning),
– or turn the programme knob to OFF and then to SPIN. Change the
spin speed if necessary and press the START/PAUSE button (the water
is drained and the washing spun).

Overdosing

3
If the OVERDOSING indicator is lit, too much detergent was used in the
previous programme. The next time you wash, observe the dosing rec-
ommendations of the detergent manufacturer and the load sizes.
16