Table of Contents
Advertisement
BATTERIES
Use ALKALINE batteries
only.
To install the
batteries:
●
1
Remove
battery cover by
disengaging the
clip at the back.
●
2
Align the polarity
of the batteries
correctly, with the
positive "+" toward
the
coil
connection,
indicated by the +
and – indicators on
the housing.
●
3
Insert (2) 9-Volt ALKALINE
batteries, with the contacts pointed inward, and press down on the back of
the batteries to snap them into place.
Some brands of batteries will require moderate force to clear the retaining
tabs.
If the batteries fit loosely, and you want to
guarantee a very secure electrical contact,
insert a piece of paper or thin cardboard
between the back of the battery and the
supporting post.
●
4
Replace the battery door.
The Low Battery Indicator will come on and stay on if the batteries need to be
replaced.
Most metal detector problems are due to improperly installed batteries, or the
use of non-alkaline or discharged batteries. If the detector does not turn on,
please check the batteries.
If the detector does not turn on, check to see that the batteries fit tightly. If the
batteries are loose, press them forward while pressing the ON touchpad. To
tighten up a loose battery, wedge a piece of paper or thin cardboard between
the back of the battery and the supporting post, as illustrated above.
the
plug
as
IN CASE OF LOOSE BATTERIES
5
Advertisement
Table of Contents
