Disassembly
Removing and Replacing the Transceiver PC Board Shield
22
1.
Remove the battery cover, battery, SIM, and antenna, as described in the
procedures.
2.
Using a Torx Plus driver with a T6 bit, remove the 6 housing screws from the
phone. Set the screws aside for re-use (see Figure 7).
Figure 7. Removing and Replacing the Rear Housing Screws.
3.
Lift the PCB shield away from the phone.
Figure 8. Removing and Replacing the Transceiver PC Board Shield.
4.
To replace, place the PC board shield onto the phone. Ensure the PCB and PCB
shield are aligned with the chassis alignment pin.
5.
Insert and tighten the 6 T6 screws to a torque setting of 14 Ncm. Do not
overtighten.
6.
Reassemble the antenna cap, SIM, battery and battery cover as described in
the procedures.
October 12, 2006
Housing Screws
Housing Screws
Transceiver PC Board Shield
MOTOSLVR L9/L72
061497o
061498o
6809510A66-O